![]() it seems to be a function of both devices given that only the acme seems to create this issue in the multiclock, and other devices seem to play fine with the acme. But if you are sequencing drums or bass from your PC to hardware, it probably will. For pads and synths, this may not be a huge deal. I don't have any of the weird swing settings or offset settings, or even divisions playing from acme. Without a hardware sequencer that can capture the sequences you made, your MIDI from the PC even going through the ERM will have some jitter in it. BUT if i leave things at that lower tempo (and we're talking about relatively high bpms, like 135), and i start up the acme, the multiclock flashes the 'clock running' band along the bottom, but then stops and doesn't pick it up. When i lower the tempo on the acme, the multiclock follows along. If i turn up the tempo on the acme to somewhere around 160 bpm, and then start it - the multiclock picks up the sync, shows the correct tempo, etc. So, i didn't suspect it.īut this is the weird problem. But it turns out that the problem was that i was syncing (or trying to) to the acme 4, which works with everything else. so, given that it syncs up immediately to the octatrack, there doesn't appear to be a problem with midi clock per se. I have no problem starting the multiclock with other clocks (analog clock, and then i tried the octatrack). Some more detailed troubleshooting today.found what the issue is, but i have no idea why this is happening. Sounds like everything will run without any problems! Can't wait to get it, DAW integration with my system has always been the intention, but it's taken me much longer than anticipated to get it done. Thanks a lot for the detailed explanation. I put the output on the scope and can confirm Multiclock's reset gate goes high when I start Reaper and stays high until I stop Reaper then if goes low, and Pams starts and stops on the gate. I set the Multiclock Channel to Gate mode with Positive Polarity and on Pams, I set Run to "Gate Sets Clock State". Really a ton of options on the Multiclock side! If you think there is a virus or malware with this product, please submit your feedback at the bottom. So far we haven't seen any alert about this product. ![]() ![]() We have seen about 3 different instances of MultiClock.exe in different location. uninstaller.exe How do I remove ADLSoft UnCompressor You can uninstall ADLSoft UnCompressor from your computer by using the Add/Remove Program feature in the Windows Control Panel. One can also set the Start Polarity to positive or negative. The application adlsoftmulticlocktriple0412s. What is MultiClock.exe MultiClock.exe is known as Multi Clock and it is developed by Fried Cookie. Channel 1 on Multiclock is set to "Analog" Channel Mode, which has a submenu called "Start Mode" which one can set to either a Gate, a Trigger, or a Trigger that skips one click. I was just a bit concerned that somebody said it didn't stop when the run receives zero gate but hopefully it's been resolved!Ī little more detail on how this is configured in my setup: I'm using output 1 TRS from Multiclock to a Y cable to Pams Clock and Reset inputs.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |